Stealth cord / Invisicord V1 Homelink hardwire, 08 Z. Constant power, wtf? Need help
#1
Registered User
Thread Starter
iTrader: (5)
Join Date: Oct 2006
Location: Jacksonville, FL
Posts: 317
Likes: 0
Received 0 Likes
on
0 Posts
Stealth cord / Invisicord V1 Homelink hardwire, 08 Z. Constant power, wtf? Need help
I searched before I attempted to install and found out that black/brown wire is 12 volt and black one remains as ground. Well, I plugged it in as such and V1 does not turn off when the car is off... what am I doing wrong?
Here is the pic of the harness (ground got disconnected when I unplugged the harness... it was plugged in before)
Here is the pic of the harness (ground got disconnected when I unplugged the harness... it was plugged in before)
#3
Registered User
Thread Starter
iTrader: (5)
Join Date: Oct 2006
Location: Jacksonville, FL
Posts: 317
Likes: 0
Received 0 Likes
on
0 Posts
Actually no, but I just did and it worked! lol... I just read on here that it was brown one and I went by that... I should have checked the red/black one too... duhhh
thanks man
thanks man
#5
Registered User
Thread Starter
iTrader: (5)
Join Date: Oct 2006
Location: Jacksonville, FL
Posts: 317
Likes: 0
Received 0 Likes
on
0 Posts
I bought my V1 from fellow forum member and he also sent me "Mike's mount" and Stealth Cord. Do some searches here and you'll find where you can get Mike's mount or some other mount
Thread
Thread Starter
Forum
Replies
Last Post