I am trying to set up a factory navigation screen and use the component inputs to set up my phone screen or a raspberry Pi or something like that. I haven't had any luck getting anything to show up on the screen, any suggestions?

 

I believe the factory nav screen was sourced from a Nissan subsidiary and uses a specific signal. No one to my knowledge has been able to use the component inputs to use other devices to display on the screen. Let us know if you find any success on this project.

 

I have some really smart friends in software/electric engineering if someone sends me a screen I'm sure they could figure it out or at least see if it's possible.

 

Looks like it already has been done?
https://www.navtool.com/nissan-350z-...interface.aspx

 

No success yet but I'll let you know if I succeed. I got a brief flicker of something to show up on the screen when I had the navigation control unit hooked up as well

 

Where abouts are you located? That would be helpful to have someone take a look at it

 

I saw that thing but the navigation screen I have has already been cut out, I don't have any of the connectors anymore. Ill have to look if I can see a wiring diagram for that thing

 

Massachusetts, USA, but check out the link I posted

 

I sent an email to that site you posted asking them about a wiring diagram for their wiring harness thing, hopefully they'll get back to me

Here's what Ive got for the display screen connector wiring from the service manual