Audio Install complete... pics inside -->
#1
Charter Member #34
Thread Starter
Join Date: May 2002
Location: -
Posts: 1,228
Likes: 0
Received 0 Likes
on
0 Posts
Audio Install complete... pics inside -->
ok, here is the rundown on the components:
- stock headunit (didnt care to mess with nav integration, maybe will swap with 8V Eclipse Pre-out in the future)
- Boston Acoustics RC620 (6.5" components in stock driver and tweeter locations) Driver required 1" spacer to clear window.
- Boston Acoustics FX6 (6.5" coaxials in rear stock locations) These rears are running off headunit power, since they dont need to much push.
- 2 JL Audio 8W3D6 (Dual 6 ohm voice coils, running parallel on each speaker, then parallel into AMP.. this gives 1.5 ohm total) These are in a custom enclosure, kind of like a stealthbox. The shop made 4 sides from MDF, then contoured the bottom with mold fabric and resin. it sits flush in stock sub location. Pics below.
- JL Audio 300/2 pushing the front Bostons. input signal from front signal from headunit. crossed over.
- JL Audio 250/1 pushing the subs. input signal from 300/2.
- 4 gauge power and ground for amps
- Dynamat extreme for doors and firewall thing.
all work done at Tweeter in Frisco...the most awesome installer... Patrick Riley, was a magician!!
here is the first pic (the front drivers)..
- stock headunit (didnt care to mess with nav integration, maybe will swap with 8V Eclipse Pre-out in the future)
- Boston Acoustics RC620 (6.5" components in stock driver and tweeter locations) Driver required 1" spacer to clear window.
- Boston Acoustics FX6 (6.5" coaxials in rear stock locations) These rears are running off headunit power, since they dont need to much push.
- 2 JL Audio 8W3D6 (Dual 6 ohm voice coils, running parallel on each speaker, then parallel into AMP.. this gives 1.5 ohm total) These are in a custom enclosure, kind of like a stealthbox. The shop made 4 sides from MDF, then contoured the bottom with mold fabric and resin. it sits flush in stock sub location. Pics below.
- JL Audio 300/2 pushing the front Bostons. input signal from front signal from headunit. crossed over.
- JL Audio 250/1 pushing the subs. input signal from 300/2.
- 4 gauge power and ground for amps
- Dynamat extreme for doors and firewall thing.
all work done at Tweeter in Frisco...the most awesome installer... Patrick Riley, was a magician!!
here is the first pic (the front drivers)..
Last edited by SKiDaZZLe; 10-10-2002 at 07:43 PM.
#2
Charter Member #34
Thread Starter
Join Date: May 2002
Location: -
Posts: 1,228
Likes: 0
Received 0 Likes
on
0 Posts
btw.. i have 30 pics (1600x1200).. only going to attach a few descriptive ones...
this is the enclosure (upside down).. you can see mold which fits like a glove inside cubby.
this is the enclosure (upside down).. you can see mold which fits like a glove inside cubby.
#5
Charter Member #34
Thread Starter
Join Date: May 2002
Location: -
Posts: 1,228
Likes: 0
Received 0 Likes
on
0 Posts
here are the amps.. we took out false bottom and mounted the smaller one on a piece of MDF.. then built a riser for the bigger amp, at the same angle...
Trending Topics
#10
Charter Member #34
Thread Starter
Join Date: May 2002
Location: -
Posts: 1,228
Likes: 0
Received 0 Likes
on
0 Posts
here are fuses for amps.. it runs through 2 grommets (sp?) made through firewall. they are on a custom piece of ABS, it is all really stealth with battery cover on. you can see huge wire loom (which has 2 4 gauge wires running through it.
#13
Registered User
Join Date: Jun 2002
Location: Dallas, TX
Posts: 777
Likes: 0
Received 0 Likes
on
0 Posts
Looks awesome, but my question (didn't see you talk about this) is...how does it sound? Actually how does the two 8" sound? I have a similar setup but with the JL 10 in the hatch right now. Going to dual 8" was an idea, but decided to wait and just use a small box in the hatch. Would love to hear how it sounds. Are you going to the Z tour tomorrow? I'll be there. PM me.
#15
Charter Member #34
Thread Starter
Join Date: May 2002
Location: -
Posts: 1,228
Likes: 0
Received 0 Likes
on
0 Posts
sounds freaking incredible. fader is on FR3.
i like trance and techno, and it comes through so crisp. the installer mentioned the Z has a good stage, eventhough the drivers are not angled in... i think the strong tweeters helps bring the stage up.
the subs absolutely pound... when i put in oakenfold/ seaman CDs, it is so awesome,... when i put in rap cds, it punches pretty hard.
i dont need 12W7 performance, since i dont like that sound... the dual 8's work awesome for the Z.
m
ps, i might go to concert... still dont have any info on meeting place...
i like trance and techno, and it comes through so crisp. the installer mentioned the Z has a good stage, eventhough the drivers are not angled in... i think the strong tweeters helps bring the stage up.
the subs absolutely pound... when i put in oakenfold/ seaman CDs, it is so awesome,... when i put in rap cds, it punches pretty hard.
i dont need 12W7 performance, since i dont like that sound... the dual 8's work awesome for the Z.
m
ps, i might go to concert... still dont have any info on meeting place...
#16
Charter Member #53
Join Date: Jun 2002
Location: ATL/Auburn U.
Posts: 522
Likes: 0
Received 0 Likes
on
0 Posts
Looks great...like others are asking how do the 8's sound?? also anyone know the approx size of the NAV box its self? Is it close to 1DIN or is ti bigger/smaller/deeper
Last edited by jtree007; 10-10-2002 at 08:18 PM.
#17
Charter Member #34
Thread Starter
Join Date: May 2002
Location: -
Posts: 1,228
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by nizl
Very nice!!! Excellent, clean, tasteful install.
How much was the $$$ damage???
Very nice!!! Excellent, clean, tasteful install.
How much was the $$$ damage???
we (I ) changed the setup like 10 times. install took 5 days total.
#19
Charter Member #34
Thread Starter
Join Date: May 2002
Location: -
Posts: 1,228
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by a_p
Very Impressive... I love the rich sound of Bouston Acoustic speakers..
if you don't mind me asking, what was the total cost of the audio components?
Very Impressive... I love the rich sound of Bouston Acoustic speakers..
if you don't mind me asking, what was the total cost of the audio components?
m
#20
Registered User
Join Date: Jun 2002
Location: Dallas, TX
Posts: 777
Likes: 0
Received 0 Likes
on
0 Posts
Well I'm not sure the plans either, but was thinking about parking in the big lot on the far side of the West End. There should be plenty of room by that time to find some parking. The only thing to think about as well is Friday is opening night for the Stars regular season. Give me a ring if you head down there....214.244.8985
Scott
Scott