I decided to do this with my little brother......first time for everything. If I don't describe things well...sorry.

Tools Needed
-Rivet gun (just in case you need to learn how to use a rivet gun)
http://www.studiocreations.com/howto.../riveting.html

-Rivets
-Razor Blade
-Scissors
-Tracing Pencil
-Drill

OK here we go.
The Product

Included with your purchase of Titek or Yaris Air Duct should be a cut out Diagram shown here. Tape Diagram to 350z I used regular tape comes off easy

Use a tracing pencil (recommended) in my case I just jumped right ahead. Just be very careful if you decide not to use a tracing pencil.

Now you can remove the paper and keep cutting carefully.


Now you should be able to pop out the cut piece

and it should look like this

Put the Titek Air Duct in the hole.....just in case you need to cut out a lil more pieces do so....just be careful.
If you follow the link on HOW TO USE THE RIVET GUN you should be ready to use the Rivet gun........and FINAL PRODUCT SHOULD LOOK LIKE THIS...

Thanx guys for the support. I just didn't want to go to a body shop and pay for Labor

 

great DIY. that must have been painful cutting a hole in the Z. haha

 

great write up!! it woudl hurt cutting into my aerosync. Not sure if i want to do it or not.

 

Thanx Guys. It took some guts cutting into the front bumper.....but hey you live and you learn.

 

hey is the titek intake duct made out of real carbon fiber or is it just an overlay?

 

Real Cf

 

+1 Real CF

 

Is there something that comes with the KIT for when it rains you can cover up the end so water doesn't go straight to the filter?

 

Doesn't come with a KIT to cover rain......this was asked before

240Zplus110: "Will this allow any water (ie. rain) to affect the air intake??"

Gin@CZP: "Thats a good question. These are proven to NOT allow any water into the intake, and will not cause any water damage. Thanks for asking!"

Gin@CZP sells the Titek Air Duct (Very fast shipping) here is the link.
https://my350z.com/forum/showthread....ighlight=titek

 

hope they come out with dual ones for the 07, very nice write up and pics.. thanks.

 

looks good wish i would of seen the titek ones before i waited 2.5 months and spent atleast double for the varis. did you have to cut a lot the styrofoam out? just wondering because your's is a little lower than mine, just wondering as far as ease of fitment. you should also sharpie the rivets, so the blend in a little imo.

 

thats why you buy two of them

 

...

 

just ordered my varis air duct today....... but i dont have a rivet gun hmmm

 

I got one at Home Depot for $16 - buying new tools should never be an issue.

 

Every time I logon to my350z I end up spending money on mods and ideas... LOL

 

Mine didnt come with a template. Do you suppose I can eyeball it?

 

^^^ I remember seeing a thread where someone posted the template... if I find it again I'll post it here...

Wait, take your time and don't you dare eye-ball it... No need to rush...

Haste makes waste...

 

If you only could see me. Im trying to make a template! LOL

 

Ok, got it !!

Here's the direct link to the posting....

and the complete thread....

and another...

and yet another....