I recently put y new pmu pads in and with the spring tensioners adjusteded at max slack, they still dont fit right like they are too thick.

any suggestions? Thanks

 

Well I know that they have been installed by a few members here with no problems.

I'm about to to my Brembo Swap (FINALLY!) & have a set of these Project Mu Sports Inner Shoes to install as well.


Go through everything step by step again. Do you have the right part#?

IS200B


When you've gone through everything again, post your results.

 

The instructions I had were pretty vague. I switched the pads over with the stocks identically but it seems like fitment is a bit off. I dont have any slid directions and I don't know the part number specifically but I ordered them off that Nismo shop on this site.

 

What were the instructions you were using? Can you post any pics?

 

they werent installation instructions they were just setup instructions from one of forsburgs threads...

i'll post up pics later

 

Im guessing you found what the problem was? Mind sharing it with the rest of us in case we run into the same thing?

 

i didnt. i was in a motorcycle accident with a dozen broken bones and i'm slow to make progress. i'lll keep everyone informed!


thanks guys

 

No problems with the install here. I used them for a whole season and absolutely loved them.

 

i noticed that my OEM rotors fit over them jst fine but my 14" wilwood rotors do not have as much depth in the hat as the stocks. i'm tyhinking that may be the problem and i hope that i did not order the wrong hats... the depth in the oem's is around 2 inches while the depth in my wilwood hatts is only 1.45". I noticed when i had my stock handbrake pads on there that they only covered about 1/3 of the available surface area on the wilwood rotors.

 

Wow! Sorry to hear about your accident! i hope you are doing well! I just installed my project mu inner sports shoes & everything bolts up just fine.. I have no clearance issues at all so maybe your right about your rotors...

 

thanks man. i'm healing slowly.

i've been using my wilwood brakes with stock handbrake pads for a while so im curious as to why this isnt working for me. i guess i need to heal and figure this out lol

im glad your enjoying your brakes though man!