so i swapped out my front rotors (backs were done a little while ago) and i was also painting my rims at the same time and got all excited to throw the rims on and forgot to pump my brakes with the cap on....soooo before i drove off i threw the cap on the master cylinder and didnt pump the brakes then when i had to stop i start pumping like crazy to get some pressure back...now my brakes are suppperrrr squishy...should bleeding them bring them back to normal?? what size rubber tubing should i buy to slip over the nipple on the caliper? anything else i should do besides bleed the breaks??

 

BRAKES - it's BRAKES.

Yes, they need to be bled.

Here's instructions that describe how to bleed properly...

https://my350z.com/forum/brakes-and-...tem-bleed.html

http://www.wikiautorepair.org/wiki/N...ing_the_Brakes