Brake Cooling Ducts
11-18-2003 | 12:33 PM
#2
Thread Starter
Registered User
Joined: Aug 2003
Posts: 1,099
Likes: 0
From: forum infested by newbs
11-18-2003 | 01:30 PM
#4
in this picture you can barely make out the prototype Nick is working on for his 350Z...
http://www.ntechengineering.com/inde...number=nt00149
http://www.ntechengineering.com/inde...number=nt00149
11-18-2003 | 03:49 PM
#6
Registered User
Joined: Jun 2002
Posts: 194
Likes: 1
From: indianapolis
I've ducted my fronts
I got 2 - 21/2" NACA ducts and mounted them to the lower engine cover shroud. I had a small shop weld a 21/2" pipe about 4" long to a multi-punch strap which I bolted to the turn stop on each front wheel. They angled the pipe and deformed one end so that it directed air to the center of the rotor. Removing the dust disks and attaching 21/2" ducting to the Naca ducts and these fabricated pieces I've got a pretty nice set up for cooling my front brakes. I've run 5 different schools this season and only used 1 set of Carbotech XP pads. I also changed fluid to Super Blue.
Thread
Thread Starter
Forum
Replies
Last Post
