need opinions on what needs to be done - camber/toe ?
#22
Super Moderator
MY350Z.COM
MY350Z.COM
iTrader: (8)
#23
Former Sponsor
iTrader: (564)
Join Date: Feb 2003
Location: Long Island, New York
Posts: 19,266
Likes: 0
Received 5 Likes
on
5 Posts
except urethane compression rod bushings are not what you want - they will bind. We looked into making them a few years ago, and ended up not moving ahead with it because you just couldn't get a bushing material that would allow the full range of motion given it's offset type design. Stock rubber, or a solid design that allows independent articulation like SPL are really the only 2 plausible ways to go.
I'd sooner use stock ones again
all of this is really just guesswork, and you're possibly throwing money away. Your safest best is not to buy anything, get the car on an alignment rack, check the specs, and examine the bushings in detail...all of them. Cars don't hold alignments forever, and some cars do a better job than others. Also highly dependent on how well it was done the last time
I'd sooner use stock ones again
all of this is really just guesswork, and you're possibly throwing money away. Your safest best is not to buy anything, get the car on an alignment rack, check the specs, and examine the bushings in detail...all of them. Cars don't hold alignments forever, and some cars do a better job than others. Also highly dependent on how well it was done the last time
Last edited by Z1 Performance; 07-07-2011 at 06:13 AM.
Thread
Thread Starter
Forum
Replies
Last Post
wanderingstuden
Maintenance & Repair
6
01-28-2016 07:03 PM
tm9293
North East Marketplace
13
10-17-2015 09:14 PM