I have a 2004 350Z that requires a compression rod bush. (front suspension)
Can someone please help me with regards to where I can buy one???

Many Thanks in advance

Phil

 

Besides the obvious place (a dealer), you can try one of the Vendors here...

https://my350z.com/forum/vendor_directory.php

... or post a WTB thread here...

https://my350z.com/forum/vendor-wanted-86/

 

If your car is stock I would just put another crap OEM one in. If you want to upgrade look at whiteline or SPL

 

yep, ebay.

 

SPL will produce loud noise going over small bumps like lane dots. But they are the best CR bushings

 

No problem with mine, load clunking noise went away once i properly installed adjustable endlinks.

 

What in the world...

$150 for SPL compression rod bushings?

The Whiteine one is only $50.....

 

Thats like complaining about the price between a diamond and a CZ.

 

The SPL bushes make a noticeable difference. They have greater ability to drive in Caster and as such your turning ability will be improved, as well as they'll last hell lot longer than oem. I also went for SPL ARB bushes which are very cheap and help with keeping the car flatter in corners.

The price might seem expensive but when you compare it to say coilovers the price isn't that bad. Not saying it replaces coilies, but def improves contact with the road. The Z should have been fitted with these as STANDARD!

 

what's spl arb bushings?

 

i needed to replace 1 on my old g35 sedan. just found a used z assembly and swapped it. if mine go on my z, ill definitely do the spl

 

Since i'm only DDing my car and could care less about performance, are there other options besides the SPL for compression rod bushing?

 

whiteline or even OEM^

 

i have energy ones, i like em

 

I have the Energy Suspension ones in stock.

Check the link:
https://my350z.com/forum/misc/538058...-in-stock.html

 

Anti Roll Bar (Sway Bar) sorry English terminology.

 

I love 'em! Got the inners,outers,and ctrl arm too

 

Sorry to high jack this thread again op, but :

How's the durability for the Energy and Whiteline compression rod bushings?

 

both are polyurethane so im pretty sure they will outlast a brand new oem rubber one by a good amount. all my bushings in the front are energy or whiteline and i love it. im about to get the energy set for the rear now

 

If you dont care about performance and you are not lowered, and want to go the cheap route just buy another OEM one. If you want something better look at Whiteline. If you want to stunt hard buy the SPL.