Anybody know the thread pitch of the 19mm nut that is used at the four corners of the rear subframe?
Thanks

 

just dont drive the car and take one off, and run to local bolt store and have its thread pitch checked.....taking one off wont hurt anything.

i wouldnt drive it that way, just take it off to check ,then put it back.

-J

 

There are basically only two possibilities: 12mm x 1.5 (fine thread), or 12mm x 1.75 (coarse thread).

 

Originally asked the question fearing I would have to wait for dealership to get nuts in, however one had some in stock. Took it to a parts store looking for a die to chase the stud threads and they said it was M14x1.5. Will confirm that this weekend.

 

Glad you found them. I was pretty sure a 19mm head was a 12mm thread, but I guess I was mistaken in this case.