Rear diff bushing pushed through
#1
Rear diff bushing pushed through
I put the Z1 bushing in there a couple years ago and just noticed it was pushing in towards the diff. Ordered SPL solids and began taking it apart. Naturally the rear nut is stripped to all hell. After messing with it for 15 minutes, I noticed the diff was real loose. With the nut still on and fully tightened, I pushed the damn diff forward and the bushing easily came out with the diff. All in one piece. Did the bushing fail and become loose? I did notice the stud is a little loose as well. How far are the threads supposed to stick out? I also measured the subframe mount and it appears to be in spec.
Thread
Thread Starter
Forum
Replies
Last Post