Sticky - icky - icky's w/ Pics
#25
Looking at Jegs site, I was trying to research a set of wheels myself. But the Bolt Circle #'s are throwing me off.
What is the actual Specs I need to have these run on my Z? Bolt Circle, Rear Spacing?
What is the actual Specs I need to have these run on my Z? Bolt Circle, Rear Spacing?
#26
New Member
Thread Starter
iTrader: (11)
Join Date: Nov 2005
Location: Tampa, Fl.
Posts: 1,130
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by rhythmnsmoke
Looking at Jegs site, I was trying to research a set of wheels myself. But the Bolt Circle #'s are throwing me off.
What is the actual Specs I need to have these run on my Z? Bolt Circle, Rear Spacing?
What is the actual Specs I need to have these run on my Z? Bolt Circle, Rear Spacing?
Back spacing = 5.5" for a 8" wide rim. However, this changes with rim width.
#30
Registered User
iTrader: (4)
Join Date: Nov 2006
Location: Naples, fl
Posts: 108
Likes: 0
Received 0 Likes
on
0 Posts
jay i see your trying to step your game up and roll like me. lol except my car isnt really rolling yet. soon. i like the set up.im going to see how the et drags hold up on the street. if they are too dangerous im just going to buy another set of draglites for the back with et streets.
#34
New Member
Thread Starter
iTrader: (11)
Join Date: Nov 2005
Location: Tampa, Fl.
Posts: 1,130
Likes: 0
Received 0 Likes
on
0 Posts
Here you go!
Tools Needed:
- Makita tile cutter/ grinder with thin metal cutting blade
- Sharpie
- Fine metal file
- 60 grit sand paper
- Primer
- T-up paint
In the first pic you can see how much I removed where I tapered it out.
Tools Needed:
- Makita tile cutter/ grinder with thin metal cutting blade
- Sharpie
- Fine metal file
- 60 grit sand paper
- Primer
- T-up paint
In the first pic you can see how much I removed where I tapered it out.
Thread
Thread Starter
Forum
Replies
Last Post
chemicalviper
Intake Exhaust
79
07-04-2020 05:16 AM
Tochigi_236
Feedback & Suggestions for Our Forum
8
09-27-2015 03:40 PM
TK2005
Exterior & Interior
6
01-26-2006 10:45 PM