My stock clutch is near its death currently and i purchased an ACT 6 puck and a heavy duty pressure plate and a JWT flywheel. Are there any accesories i will need to install these properly. I do not need the adjustment too because i am getting it installed at a local shop. If i need any extra parts like bearings and such then i could use that information so i dont have to delay my clutch install more.

 

may want to get a new throwout bearing...

new pilot bushing too...

OEM VQ35DE Z33 350Z 6MT Pilot / Crankshaft Bushing

 

ok thanks thats what i was wondering about

 

i need to add the factory throwout bearing to our web site... will do so tommorow morning..

 

may want to NOT put that disk in your car...its going to be nasty to drive

 

yea i cancled that order, im goin with the clutchmasters FX300 kevlar clutch now instead. it was takign too long for shipping anyway with the 6 puck because of backorder.

 

Do any of these aftermarket clutch kits come with a clutch alignment tool?

 

they all come with the alignment tool. and i just changed again im going with the JWT clutch and thast final.

although the FX300 is a raging beast that will outperform and probably outlast the JWT it was 100 less and im all about that right now.