Posting in right section now... (I hope!!)

Hi Guys,

I picked up one of these off a dealer over here, havnt got it here with me but I think its the one with the 15mm pipes.

Do I need the one with the 9mm pipes or do I just need to replace the hoses and has anyone fitted one and where did you fit it? Am thinking of fitting it too the engine cover (Any thoughts??)

If it is 9mm do the hoses just pull off the PCV valve and do I just fit the new hose straight on to the PCV? Or will I need a clip?

Cheers in advance,

Mark

 

Anybody with any ideas?

 

Hose goes straight onto the PCV from the catch can then the other one goes to the lower part of your plenum. Use the existing clips form the old hose, they should work fine.

 

We can haz picz?

 

pics for the zigen website:

 

Yep, those are the ones... unfortunatly even though they are sold for the 350z, they dont have a fitting kit or instructions.... Grrrr!!!

Also the only place to fit seems like at the front of the engine bay. I am going to attach mine to the front of the engine cover... The only issue is doubling back to the plenum and squeezing the hose so I need some braided hose and some fitted bends.... I think I need 2 u bends... Sizes of the 2 ends would be cool if anyone knows but I will undo the pipe tomorrow if not!

 

Looking nice mate! ;-)