sooo i just bought a clutch masters FX400 4 puck clutch and i am gettin ready to be makeing a turbo kit and i just want to know what flywheel i should run. this car is daily driven and i know the 4 puck is goin to suck but i need for the the power ill be maken in a few months. which flywheel you guy think i should run? fidanza, ACT, JWT,??? suggestions are appreciated! thanks in advanced!

 

Don't everyone post all at once lol just seen what people are using oout there

 

Well, if it counts for anything. When I get around to ordering I'm going to get the ACT. But then again I'm only doing N/A power.

 

if you are going FI you might want to go with a twin or triple disk setup

 

I don't plan to go too wild with the tubro just around 400whp would be nice lol....I'm thinkn towards the fidanza or act but lookn for input

 

In reality, that stock dual mass flywheel is the best and if its not worn, I wouldnt bother replacing it.

Otherwise, it doesnt really matter. similiar priced single mass FW are all about the same. get whats cheapest and in stock. The JWT is fine.

 

I am only N/A, but I have been using JWT for a long time with very good results.

When I was planning to go 'mild F/I' -which will have to wait a long time now- I chose the Streetlight ACT flywheel. I will still get this for my N/A car.

 

Right on guys I'm probably goin with the jwt since its about 400 but I saw a refirbished fidanze for only 280 so I might just use that

 

just got the act street lite flywheel for a ridicules price from THmotorsports!! go there for clutchs hellla killer prices