Ok, WTF did I break now?!?!!?!? lulz. Clutch/Drivetrain Problem
Ok, went to the track today. Preloaded the clutch and launched at 4500. It wheel hopped a bit, I let off and get back on her. It pops out of gear and I cant get it back in gear so I coast the rest of the way knowing I screwed up something.
The car does go into gear but grinds every time. Cruising, the car seems perfectly fine. Slipping it into 1st seems to cause the worst of the grinding. I also noticed that the clutch was very very soft.
Any ideas fellas? Master slave cylinder maybe? That would explain the soft clutch and that it might not be fully disengaging....
I have zero luck at the track it seems.
edit: I actually said "FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFUUUUUUUUUUUUUUUUUUUUUUUU U" when i was coasting down the track, ROFL!
The car does go into gear but grinds every time. Cruising, the car seems perfectly fine. Slipping it into 1st seems to cause the worst of the grinding. I also noticed that the clutch was very very soft.
Any ideas fellas? Master slave cylinder maybe? That would explain the soft clutch and that it might not be fully disengaging....
I have zero luck at the track it seems.
edit: I actually said "FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFUUUUUUUUUUUUUUUUUUUUUUUU U" when i was coasting down the track, ROFL!
Bump (after 8 minutes) for answers.
Joined: Mar 2007
Posts: 5,311
Likes: 0
From: Dallas/NewYork/Michigan/Korea
throw out bearing?
If you not sure, check out my video clip.
https://my350z.com/forum/engine-and-...-fly-help.html
If you not sure, check out my video clip.
https://my350z.com/forum/engine-and-...-fly-help.html
Last edited by Chef-J; May 24, 2009 at 08:55 PM.
Abzolutely Zexy
iTrader: (5)
Joined: Aug 2003
Posts: 5,504
Likes: 3
From: Lithia/Tampa, Flo-Rida Bishes
throw out bearing?
If you not sure, check out my video clip.
https://my350z.com/forum/engine-and-...-fly-help.html
If you not sure, check out my video clip.
https://my350z.com/forum/engine-and-...-fly-help.html
Trending Topics
throw out bearing?
If you not sure, check out my video clip.
https://my350z.com/forum/engine-and-...-fly-help.html
If you not sure, check out my video clip.
https://my350z.com/forum/engine-and-...-fly-help.html

FFFFFFFFFFFFFFFFFFFFFFFFFUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUU
Joined: Mar 2007
Posts: 5,311
Likes: 0
From: Dallas/NewYork/Michigan/Korea
Humm do you feel like clutch issue? I mean it sounds like it could be tranny. But hope not.
What clutch u running with that monster?
What clutch u running with that monster?
once it's in gear it feels tight, like normal. its just a matter of the terrible grinding going into gear. 1st and 2nd are the worst and it gets better the higher i go.
It's hard to tell. Could be a clutch issue or you messed up your sychros. It's really hard to tell. My guess is the hard launch glazed your clutch, and now it's not disengaging completely, causing the grind.





)