As it says what would be one of the best VQ motor builds...
What would u use as in pistons, crank, rods, heads, cams, etc...
Would u step it up and throw in a vq40 crank, stroke it...
Tell us what u think or know!!!

 

thousands of combinations, do some research.

 

IBTL

 

My idea is you need at least $15k to get started.

 

20k..... Shoot me some ideas.

 

Step 1: Drop car off at Forged/GTM
Step 2: give them $20k and tel them to go wild
Step 3: pick it up...

PM Sharif or Sam and they will get you started.

 

Lol. Thats the thing i want to do this project my self, from the bottom-up!!

 

That's a whole other story. have you done a build before or worked with FI? Most people leave the big builds to the shops. You can't beat experience. check out bambam or Alberto on their builds and it'll give you an idea of where you need to start.

 

I really just want a n/a build & is there bigger cams than 280s if so what....

 

One of many big NA builds that likely will spend your $: https://my350z.com/forum/na-builds/4...zcargarge.html

 

why not FI? Ill b damned if i put that much time and money in a car for 300hp.

10K will get u a SWEETTTTT turbo set up ST or TT a great tune and reliability. Then u have money to blow

 

+1 Na builds on the Z are for people with deep pockets but are afraid of true power..

 

I want a nasty vq35 n/a... I know what u mean by 300hp build but u must got mislead then. I want a bas a$$ vq35. And again do thay make bigger cams besides the tomie 280s

 

That thread about the 4.15L Na build is going to be the most extreme Na build out there so you're best bet is to match him on his build. Why would you want bigger cams than 280? Those are massive and will be more than capable for the extreme build you're going for.

 

seriously? A nasty auto 300hp Z? For 20k i would Trade in your car and get a 6spd Nismo Z for starters.

also research the NA section!

 

I never said anything bout havin 300hp...lol and thanks for the info. 280s seem like thay would work good too.

 

http://www.bulletproofautomotive.com...hp?category=98

 

Why do you guys participate in this ****. THeres so many more fun and cool threads...

 

I was bored and at work to be honest haha. Is it me or has it been kinda slow on the forums lately...

 

Op Start here.

Injected Performance 4.15L Stroker Short Block Assembly
http://www.injectedperformance.com/e...D=10416&VID=36

Or for the do it your self
Brian Crower VQ35DE 4.15L Stroker Kit w/ Darton Sleeves
http://www.injectedperformance.com/e...ID=7343&VID=36