When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Made some really good progress. Just finishing up the wiring and some of the small things like flushing lines and tightening bolts. Then it is time to start her up! Aiming for Saturday!
I was quite suprised that the exhaust is stilll tolerable. Long tube headers, no cats, four foot long mid/x-pipe and to small Moroso spiral flow mufflers with turn downs before the diff. Sounds amazing!
SHE'S ALIVE!!! Congrats Quamen on getting her running! What's next on the list to button her up???
I have to finish looming all the wires in the engine bay and put the seats back in the car. Have to adjust my shifter cable also. I didn't loom the wiires when I ran them in case I had an electrical problem.
I should be taking it for a quick spin later this afternoon. Tuning will start this week after I put some miles on it.
I have to say that I love this Electromotive standalone. It takes about an hour to run through all the fluid dynamic calculations and then you enter the variables and it generates a darn good base map! Started right up!
I have to finish looming all the wires in the engine bay and put the seats back in the car. Have to adjust my shifter cable also. I didn't loom the wiires when I ran them in case I had an electrical problem.
I should be taking it for a quick spin later this afternoon. Tuning will start this week after I put some miles on it.
I have to say that I love this Electromotive standalone. It takes about an hour to run through all the fluid dynamic calculations and then you enter the variables and it generates a darn good base map! Started right up!
Nice!! So is it a better solution than HP Tuner Pro? This is the software I was going with. So you kept all of your accessories right? I.e AC....