When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I blew up my 3 350 and i need to put a new engine back in. I do not want the stock weak vq engine in there so i was looking around to see what to put in but i cannot find any imformation. I would like to know if the HRs will mount up and also if any jdm engines will fit and what kind of modfications are needed for either.
the thing is i got a check for 4000 dollars and the shp is putting it in and they are pretty flexible on how much work they have to do just not anything serious so i am seing what wil work. the hr will be a good platform in case i want to put in forced induction. WIll it mount right up? what is needed?
There's been several posts by somebody associated with a race team that successfully put a HR motor in a DE car. It was not trivial - there's a whole lot more than just swapping blocks, sensors, computers, harnesses, etc.
There's been several posts by somebody associated with a race team that successfully put a HR motor in a DE car. It was not trivial - there's a whole lot more than just swapping blocks, sensors, computers, harnesses, etc.
- I looked into this briefly and I believe the trans mounts were an issue as well. HR into a DE shell is not easy.
- I looked into this briefly and I believe the trans mounts were an issue as well. HR into a DE shell is not easy.
I agree, not worth the time or cost IMO. I even considered at one time swapping the vq37 in my Z, Again, cost vs gains suck. If you got 4k theres not much you can do unless your gunna throw dough ontop of that 4 k. Midas well pick up a mild build long block DE. besides, HR parts are expensive and hard to come by. They dont even use the same radiator as a DE ffs. Plus you have to use a HR tranny and all that jive. 4k budget, Buy a built long block and boost it later..