removing bellhousing from transmission
#1
Registered User
Thread Starter
Join Date: May 2013
Location: Seattle
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
removing bellhousing from transmission
Hey Guys,
I am looking at the FSM for a 2004 350Z and I am seeing that it guides you to have to take apart the whole rear of the transmission to remove the bellhousing from the transmission. I am going to need to remove just the front bellhousing to have 5/8" machined off (or does anyone know a machine shop that can to it without taking the transmission apart??) for using this on a 1JZ motor
For people that have taken these apart before, does the front half of the bellhousing come off without removing the shifter and all the little bits in the tail end of the transmission? or do i have to remove the tail end first?
thanks!
Marko
I am looking at the FSM for a 2004 350Z and I am seeing that it guides you to have to take apart the whole rear of the transmission to remove the bellhousing from the transmission. I am going to need to remove just the front bellhousing to have 5/8" machined off (or does anyone know a machine shop that can to it without taking the transmission apart??) for using this on a 1JZ motor
For people that have taken these apart before, does the front half of the bellhousing come off without removing the shifter and all the little bits in the tail end of the transmission? or do i have to remove the tail end first?
thanks!
Marko
#3
Registered User
Thread Starter
Join Date: May 2013
Location: Seattle
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
got the bellhousing off, it just needed some more jiggling at an angle it it popped right off. what is this plastic piece sitting inside the transmission near the shift rod for?
cheers
Marko
cheers
Marko
Thread
Thread Starter
Forum
Replies
Last Post
Gruppe-S
Body Interior
13
05-16-2016 10:42 PM