VH45DE questions
09-15-2013, 06:55 AM
#21
Registered User
Thread Starter
Join Date: Sep 2013
Location: Sweden
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Thanks man, thats the one i was planning to use! See now that they only have one in stock, wasnt planning to buy it just yet, hope theyll keep selling them atleast a few more months. Have seen two other companies selling them but these seem superior.
09-17-2013, 11:04 AM
#24
Registered User
Thread Starter
Join Date: Sep 2013
Location: Sweden
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
dfhkjgfdgjfdfhjkj
Quick update; engine delivered, yey!
Engine oil smelled and looked good, might have had a recent oil change before it hit the scrap yard. Clean all around the block, no visual leakage. The rocker covers have been resealed so either the old ones went bad or some work/service has been carried out under them. Harness was cut behind the engine but only splitting the two cylinder bank harnesses for some reason, can be soldered without problems. I have a Q45 MAF laying in the garage from an old build but it didnt have the same connector, it has got three pins but the engine MAF connector has four pin holes but three wires so i might be able to get them cooperating anyhow. Fortunatly also got the ecu so i dont have to chase one down.
On my cell so not sure pic will upload..
Engine oil smelled and looked good, might have had a recent oil change before it hit the scrap yard. Clean all around the block, no visual leakage. The rocker covers have been resealed so either the old ones went bad or some work/service has been carried out under them. Harness was cut behind the engine but only splitting the two cylinder bank harnesses for some reason, can be soldered without problems. I have a Q45 MAF laying in the garage from an old build but it didnt have the same connector, it has got three pins but the engine MAF connector has four pin holes but three wires so i might be able to get them cooperating anyhow. Fortunatly also got the ecu so i dont have to chase one down.
On my cell so not sure pic will upload..
Last edited by david.fryklind; 09-17-2013 at 10:48 PM.
Thread
Thread Starter
Forum
Replies
Last Post
