I need to remove this wiring harness that's just behind the battery to run some wires for my gauges. Any idea's? I've tried un-threading it and prying it off, but with no success and I don't want to damage anything. Any help is appreciated.

 

No one has ran wires through here before? Anybody?

 

Pretty sure Injected Performance just poked a hole thru the rubber boot and sealed the are with silicone after running a couple wires....on my build.

 

Just as previously mentioned, I ran wires through the firewall by poking the them and using silicon sealer around the wires. I did this several years ago and I have never had any problems!

 

I ran the power wire for my amp through there, using this guide:

http://liljerk.morpheus.net/350Z/firewall/

You shouldn't have any trouble with smaller wires for your gauges.

 

Sweet thanks guys! I was thinking about it this morning about cutting the rubber boot a little bit just to squeeze the wires through then use some sealer to seal it off. I was on to something haha. dcains, thanks for the link It'll help me out a great deal I appreciate it!

 

You're welcome.