Injector randomly jump to 100% duty cycle on decel
#1
Registered User
Thread Starter
iTrader: (4)
Join Date: May 2012
Location: NEW HAMPSHIRE
Posts: 137
Likes: 0
Received 0 Likes
on
0 Posts
Injector randomly jump to 100% duty cycle on decel
Hey all.. so long story short my car was just finished and when I went to street tune it with the builder the car would randomly have the injectors go to 100% duty and the a/f pegged at 10 on the afr.once this happens if you reflash it it would be fine for 10 mins or an hour no telling when it would do here's a guick build sheet of the motor... Please any help would be great. And we did try another ECU no difference
Motor specs
Closed deck block machined for HR gaskets
Balanced/blue printed
Rev up oil pump, Boundary billet pump gears
EPS oil gallery kit
King main bearings
Dynasty griddle
Manely rods
King rod bearings
Wisco Pistons 0.20 over 8.5-1
Arp L19 head studs
All arp hardware in the motor
Tomei headgaskets
Manely valves/springs/retainers
Heads fully ported
Intake port matched
Hondata intake gasket
Kinetics intake manifold
Bosch 1050cc injectors
Motor specs
Closed deck block machined for HR gaskets
Balanced/blue printed
Rev up oil pump, Boundary billet pump gears
EPS oil gallery kit
King main bearings
Dynasty griddle
Manely rods
King rod bearings
Wisco Pistons 0.20 over 8.5-1
Arp L19 head studs
All arp hardware in the motor
Tomei headgaskets
Manely valves/springs/retainers
Heads fully ported
Intake port matched
Hondata intake gasket
Kinetics intake manifold
Bosch 1050cc injectors
#2
350Z-holic
iTrader: (13)
what are you tuning with? Assuming Uprev?
Thread
Thread Starter
Forum
Replies
Last Post