Hey guys, me again.

So I have the cam sprockets all lined up according to FSM with dowel placement. I confirmed this by putting on the sprockets together with the secondary chain on them. However, I was wondering if the cams are correct. According to FSM, the cam lobes on Cylinder #1 intake and exhaust face each other. Which they appear to do in my picture below. However, Cylinder 6, the valve lifter is pushed downward, again the cam sprockets are aligned with timing cover marks and chain marks.





Now on the drivers side, the cam sprockets are also aligned properly and the chain is aligned properly. But the lobes are a little different. None of the valve lifters are pressed down.





Hopefully someone can help me out here before I close the cover and start the car up and have it implode lol