I recently bought the Nismo Cams for my G35. I figured while the installers had my engine open I might as well get a few other parts replaced. I know a lot of people suggest getting the Rod Bolts replaced. Is there anything else I should do at the same time? I don't plan on going the FI route.

Down the road I plan on getting headers, plenum, UR pulleys, intake, and the ECU remap.

 

Valve springs! Please post your review after you test drive.

 

no need for anything else with the NISMO cams

 

What will valve springs run? $$$

 

http://www.z1auto.com/prodmore.asp?m...ine&prodid=922

 

hell, if u saved on ur cams, u mite as well try that vtc pulley, the cams are gonna rob some power at the lower end, if daily driving is in ur cars future, id get this.

 

there is no need for the vtc pullies with the base model NISMO cams - they are so mild that they barely affect the bottom end. The VTC pullies are designed for much higher lift cams

 

upper gasket kit...

http://www.performancenissanparts.co...oducts_id=1809