Ls1 swap on uk right hand drive 350z
#1
New Member
Thread Starter
Ls1 swap which clutch would You recommend daily
Hi there my name is Andy and I've completed the swap and the engine is running lovely, I have a problem though with the clutch i think it is contaminated and even since I've been driving the car it has a juddering when you engage gears but once engage it's fine so I'm going to take the gearbox out and replace it with another clutch can I have some recommendations on a replacement clutch. If it helps the engine produces 450 bhp and a cd09 gearbox, many thanks Andy
Last edited by Nismoandy; 10-22-2021 at 12:59 AM. Reason: Trying to ask members for their advice
#2
New Member
What are you using for a trans? If it’s adapted to the stock unit I would be looking at the adaptor plate/install as step 1.
The following users liked this post:
Nismoandy (10-22-2021)
#3
New Member
Thread Starter
#4
New Member
iTrader: (4)
If the clutch plate contaminated it would be slipping at high load not while shifting. Maybe check the slave cylinder, bearing and fork.
Is it using 350z clutch? Southbend has a lot of single plate clutches that are good for up to 800+ Ft-Lb and they drive good and not too expensive.
Is it using 350z clutch? Southbend has a lot of single plate clutches that are good for up to 800+ Ft-Lb and they drive good and not too expensive.
The following users liked this post:
Nismoandy (10-22-2021)
Thread
Thread Starter
Forum
Replies
Last Post
DaytonaBlueZ33
Engine & Drivetrain
5
11-07-2016 04:10 AM