FS: 08 VQ35HR motor/trans/etc,$4200!
Thread Starter
Vendor - Former Vendor
iTrader: (3)
Joined: Nov 2012
Posts: 432
Likes: 0
From: Dirty South
we have a perfect condition VQ35HR motor set out of a 2008 350z with only 6,000 miles on it! the car was wrecked, we pulled the motor out while the car was still in running condition, so we know as a fact it runs and shifts good!
but we have EVERYTHING needed to either swap into a non-hr car or if you wanted to even put it in a different chassis such as a s14 etc...
so it is:
-hr motor
-hr 6spd trans
-engine harness
-ecu
-mafs
-clutch/flywheel
-drive shaft
-and all accessories on motor, etc...
the entire package is $4200
please call for if you have any questions!
ps. we also have the gauge cluster/chassis harness and other things that may be needed for a conversion is needed.
but we have EVERYTHING needed to either swap into a non-hr car or if you wanted to even put it in a different chassis such as a s14 etc...
so it is:
-hr motor
-hr 6spd trans
-engine harness
-ecu
-mafs
-clutch/flywheel
-drive shaft
-and all accessories on motor, etc...
the entire package is $4200
please call for if you have any questions!
ps. we also have the gauge cluster/chassis harness and other things that may be needed for a conversion is needed.
Last edited by JGYMotorsports; Feb 13, 2013 at 08:14 AM.
I'll put it in your truck for free! 
Years ago.......probably around 2002, I had a guy want to buy an SR for his sentra. He kepted asking about putting it in the car and if that was included......we had a difficult time understanding each other.
He shows up in a '91 or '92 Sentra and asks for a 14mm wrench.............I roll with it. He takes the passenger side seat out, we load the motor into the front part of the car where the seat goes.........he puts the seat upside down over the motor..........and tells me that his "partner" like riding in the back.......his buddy gets in the back seat behind him and they leave.
........anyway, I like that story
Here's the photo of it:

Years ago.......probably around 2002, I had a guy want to buy an SR for his sentra. He kepted asking about putting it in the car and if that was included......we had a difficult time understanding each other.
He shows up in a '91 or '92 Sentra and asks for a 14mm wrench.............I roll with it. He takes the passenger side seat out, we load the motor into the front part of the car where the seat goes.........he puts the seat upside down over the motor..........and tells me that his "partner" like riding in the back.......his buddy gets in the back seat behind him and they leave.
........anyway, I like that story
Here's the photo of it:
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post




