Clear Corners
Thread Starter
Registered User
iTrader: (3)
Joined: Feb 2005
Posts: 302
Likes: 0
From: Newark, Delaware
I am new to the Z. How do I get to the Blinkers so I can put some clear corners in. Also...where can get some clear corners. Also...where can i get some red vinyl lay-overs for my reverse lights.
Thanks in advance,
Mike
Thanks in advance,
Mike
I don't know if you *have* to, however it would certainly be easier if you did. Two screws each side, very quick to replace. You could probably get by with just taking enough of the bumper off to access the areas.
Getting to the headlight blinkers do not require taking the front bumper off. There is a thread in here that has detailed instructions on changing bulbs.
Here is a thread on Changing the bulbs that Ares wrote:
https://my350z.com/forum/showthread....threadid=55808
Here is a thread on Changing the bulbs that Ares wrote:
https://my350z.com/forum/showthread....threadid=55808
the process to take off the bumper will expose some other potential venues... if you at any time during the process see that you can get to it; go for it.
I jack up the car; remove the wheel wells and thats it. others go farther and remove the skidplate, and then there are those that go all the way and remove the bumper. you have to remove all of these in that order anyway; after each step see if you can get your hand in there; with a VERY short screwdriver(<3") you can do it after only the wheel wells.
I jack up the car; remove the wheel wells and thats it. others go farther and remove the skidplate, and then there are those that go all the way and remove the bumper. you have to remove all of these in that order anyway; after each step see if you can get your hand in there; with a VERY short screwdriver(<3") you can do it after only the wheel wells.
Thread
Thread Starter
Forum
Replies
Last Post
Colombo
Forced Induction
35
Nov 9, 2020 10:27 AM
CFAUVEL
Exterior & Interior
3
Oct 1, 2015 03:20 PM




