Driver's Side Left Foot Rest
The plate on the left side where you could rest your foot was getting loose, so I attempted to tighten it up. I removed the 5 screws of the plate to get to the base, and then tried tightening the two plastic flat head type screws...
Didn't work though. I pulled off the whole thing to see underneath, but didn't see how I would tighten it up. I put everything back on, and now it's looser than ever.
Any suggestions?
Thanks
Didn't work though. I pulled off the whole thing to see underneath, but didn't see how I would tighten it up. I put everything back on, and now it's looser than ever.
Any suggestions?
Thanks
Trending Topics
to the OP: I remember reading a thread on this subject not too long ago, and someone actually came up with a way to make it tight again. (without rebuying the whole bloody thing) It involved rubber bands I know for sure...and electrical tape or something?? I can't remember very well, but it seemed to be very effective. It shouldn't be too hard to find.
Originally Posted by stepuckey
to the OP: I remember reading a thread on this subject not too long ago, and someone actually came up with a way to make it tight again. (without rebuying the whole bloody thing) It involved rubber bands I know for sure...and electrical tape or something?? I can't remember very well, but it seemed to be very effective. It shouldn't be too hard to find.
Originally Posted by DukeEntDotCom
thats what i found, my dead pedal is loose too but once i get time ill be doing this.
DukeEntDotCom: awesome man, that's the one I was talking about. Glad you were able to find it. If that's what you decide to try, you should make a quick thread/post and let us know if it really does work (well.) Good luck
Originally Posted by 68Stang
dead pedal.
i would check to make sure that when u put it back on that the rubber/plastic black thing is in place and that the carpet didnt get under there.
Thread
Thread Starter
Forum
Replies
Last Post
Gruppe-S
Body Interior
13
May 16, 2016 10:42 PM
CFAUVEL
Exterior & Interior
3
Oct 1, 2015 03:20 PM






