Gauge Pods, passenger side knee area?
#21
Charter Member #34
Join Date: May 2002
Location: -
Posts: 1,228
Likes: 0
Received 0 Likes
on
0 Posts
you wont lose voice if you run the outputs to an amp, and then to a speaker. then you run a relay to mute the radio when the voice comes on. you need a 6v relay to do this.
also, defi d-gauge series gauges are what i used... they look a little different than stock in the dayligh, but match exactly at night..
see here: http://tigersharkcorvette.com/Mercha...100-004-DGAUGE
m
also, defi d-gauge series gauges are what i used... they look a little different than stock in the dayligh, but match exactly at night..
see here: http://tigersharkcorvette.com/Mercha...100-004-DGAUGE
m
#24
Charter Member #34
Join Date: May 2002
Location: -
Posts: 1,228
Likes: 0
Received 0 Likes
on
0 Posts
oh yeah... tigersharkcorvette.com gave me like 10% off of sale price when you order 3 or more gauges....
1 boost and 2 egt came out to about $460 shipped. (tax included due to in-state order)...
if you do call tiger shark.. ask for keith.
m
1 boost and 2 egt came out to about $460 shipped. (tax included due to in-state order)...
if you do call tiger shark.. ask for keith.
m
#25
Registered User
Join Date: Jul 2003
Location: Detroit, The Motor City
Posts: 949
Likes: 0
Received 0 Likes
on
0 Posts
I was thinking someone should make a gauge pod that fits in between the windshield and the stock gauge pod. It would sit on top of the stock gauges and could have channels for the defrost air to hit the windshield. Any fiberglass or plastic masters around? I think this would be the best place, all your gauges would be in the same spot. It just takes a little fabrication, and I'm no good at that.
#30
Danny Lee from Technosquere sent me a E-Mail in answer to this question and said "no it don't not work" and also said about the price of the Techtom FLASH ECU REPROGRAMMING SYSTEM is $5,000.000. The MDM-100 works or not in the 350Z? 5,000.000 is the price for the Techtom FLASH ECU REPROGRAMMING SYSTEM ? Sound too much for this interface and software.
Last edited by fergraz; 06-03-2004 at 06:15 PM.
Thread
Thread Starter
Forum
Replies
Last Post