I am re-painting the scratched POS plastic and need to remove this to paint it.
I would like to remove everything that is black plastic around the vent



Anyone know how?

As a side note; All this black rubber paint from the factory is sprayed over a gray enamel paint, the plastic is BLACK to begin with! I don't understand why they even paint it!!!! At least the door handle covers are like this.

<-- prays he doesn't have to remove the door panel!

 

Here is a post I found some time ago, originally posted by VO. You want to start looking at post #6 Hope this helps out.


https://my350z.com/forum/maintenance...dow-motor.html

 

Damn it, I seen that bolt but when I loosened it a bit I didn't feel any give in the vent. I will have to try again I guess.

Thanks

 

ARRRRRRRRRRRRRRRRR!!!!!!!!!!!!!!!!!! I lost the bolt down in the door!!

So I pulled the back some of the door just enough to see behind the vent, it seems I will need to pull the panel off as it has a few screw holding it from the inside, as well as to retrieve the screw I dropped.

 

take the door panel off its not that hard, 5 min. tops