Few months back, i had to remove the driver's weather strip to remove the A or B pillar, I removed both of them anyways. Before i removed the strip, i heard wind noise from the B pillar side. But now i hear the wind noise from the A pillar side almost right next to my ear. When i look at the strip near the A pillar, the window doesn't roll up in between the strip gap. About like 2~3 inches are not sitting on the strip. Will I be ok if i use silicon to extend out the strip to prevent from the air coming in from the gap? OFC, i need to wait till it drys before i roll up the window.

 

Any ideas

 

Sure

 

Anyone else think that this is OK? WIll it even work?

 

Just buy a new weather strip.

 

did you check to make sure it's all tucked into the right spots on that aluminum bar that screws into the a pillars?

 

Yes i made sure that it all tucked in...but stilll the window doesn't go onto the strip

 

silicone the window shut. seems like your best option.

 

i'm wondering if silicon is soft enough to cover up all the gaps between the window

 

i loled