Do Luck front bumper fitment
#21
Registered User
Join Date: Mar 2009
Location: Dover, Delaware
Posts: 908
Likes: 0
Received 0 Likes
on
0 Posts
I also drilled 2 holes on the underside at the lowpoints on each side of the front bumper (approx 5/16") to allow drainage of any water accumulation on the inside of the bumper. Nothing major, but couldn't hurt =) just remembered about that also lol
#23
Btw, for a replica, is this pretty good fitment? Is this a easy fix for the body shop? I would like to eliminate the gap between the bumper and headlight as much as possible, wondering how hard or easy it will be:
Last edited by User 42426; 10-01-2011 at 06:37 PM.
#28
yea, just asking about the gap from the front of the bumper and the front of the headlight, not the sides. You see how on the driver side headlight, the lines of the bumper aren't straight, and swervy. Just wondering if the body shop can fix that to make it "flush"...
#31
Registered User
Join Date: Mar 2009
Location: Dover, Delaware
Posts: 908
Likes: 0
Received 0 Likes
on
0 Posts
Wow...not sure what's going on with your right side bro. that edge should def be up under the light fixture, not in front of it but i'm looking at where it meets the fender and idk...can you post up some more angles? and on the left side it looks like under the light housing is pushed in?
Thread
Thread Starter
Forum
Replies
Last Post
ars88
Zs & Gs For Sale
18
04-04-2016 07:52 AM