04 G35 w/ Greddy Twin Turbo kit
#81
Registered User
iTrader: (2)
![Default](https://my350z.com/forum/images/icons/icon1.gif)
Originally posted by accordfreak
how hard was it taking out the tranny? so a tranny jack is highly recommended? did you have plenty of room to work with, with the jack stands? what was the hardest part when you took out the tranny? Do you have a DIY on taking out the tranny?
btw the car looks good.. hopefully the rebuild will go smoothly
how hard was it taking out the tranny? so a tranny jack is highly recommended? did you have plenty of room to work with, with the jack stands? what was the hardest part when you took out the tranny? Do you have a DIY on taking out the tranny?
btw the car looks good.. hopefully the rebuild will go smoothly
The tranny was actually pretty easy, I reccommend the tranny jack because it's still pretty heavy. I had jack stands on the front and rear end of the car and yes there's plenty of room to work, you probably want to jack it up higher than I have it because I had to lift the front a little more to get the tranny out. I'll have articles on my rebuild including taking off the tranny on my website soon. It's really not that hard though w/ that jack, I got it from Harbor Freight if you have one local that's even better, if not you can order the jack off the net for 129 or so. I'm actually trying to find a engine now. Hope that helps
1. make sure you have the wiring harness all removed and breather hose
2. I dumped the oil because I didn't want it to spill all over my garage by accident
3. remove shift **** and shifter
4. remove cat mount bracket
5. remove rear engine mount member
6. we losened all the tranny bolts except the top two and put the tranny jack under the tranny. If you have TT kit you might have to take off one of the wastegates.
7. take off all the bolts and remove tranny.
here's the tranny jack I used http://www.harborfreight.com/cpi/cta...temnumber=3185
#84
Registered User
iTrader: (2)
![Default](https://my350z.com/forum/images/icons/icon1.gif)
Originally posted by accordfreak
thanks for the info! i saved it all in my g35 folder for future use lol
can't wait to see the websight up and running.
thanks for the info! i saved it all in my g35 folder for future use lol
can't wait to see the websight up and running.
#85
Registered User
iTrader: (2)
![Default](https://my350z.com/forum/images/icons/icon1.gif)
Finally got my block and dropped it off at AEBS for some work, not the stroker but the internals build. Previously was going to get it done by SGP but didn't feel it was cheap to spend 900 just on freight so went local and it's cost cheaper for the same work SGP was going to do so even better for me. Also to get the work out of state sort of sucks because they're so far away if something happened and you had to send it back that's another charge just for them to check it out.
#89
Registered User
iTrader: (2)
![Default](https://my350z.com/forum/images/icons/icon1.gif)
Originally Posted by roncfpz
Congratulations! Looks like it's been a long time coming. Nice numbers.
Thread
Thread Starter
Forum
Replies
Last Post
Vigman
Maintenance & Repair
17
11-17-2015 04:34 AM
EnjukuRacing
Engine
0
09-11-2015 08:30 AM