Procharger cog/belt dimensions?
#1
Procharger cog/belt dimensions?
I am looking to get the dimensions for a few different things regarding a Procharger.
-What width cog type belt is used on the cog on the back of the headunit?
-What is the Pitch of the teeth?
If I am not mistaken it is a 8mm pitch for the cogs and they use some sort of poly chain timing belt. However, I am not sure as to what the width is.
Thanks in advance.
-What width cog type belt is used on the cog on the back of the headunit?
-What is the Pitch of the teeth?
If I am not mistaken it is a 8mm pitch for the cogs and they use some sort of poly chain timing belt. However, I am not sure as to what the width is.
Thanks in advance.
#2
Registered User
iTrader: (1)
Join Date: Aug 2005
Location: Wilmington, NC
Posts: 123
Likes: 0
Received 0 Likes
on
0 Posts
The pitch is 8mm and Procharger uses a 30mm wide Gates PowerGrip belt.
I was having a lot of problems with these belts breaking under higher boost, so I machined out the flange on the idler pulley and switched to a wider (36mm vs 30mm) and stronger belt (Gates PolyChain vs PowerGrip). No problems anymore.
I was having a lot of problems with these belts breaking under higher boost, so I machined out the flange on the idler pulley and switched to a wider (36mm vs 30mm) and stronger belt (Gates PolyChain vs PowerGrip). No problems anymore.
Last edited by race4it; 08-31-2006 at 01:55 PM.
Thread
Thread Starter
Forum
Replies
Last Post