AAM Exhaust RANT
#101
Registered User
Join Date: Sep 2007
Location: florida
Posts: 42
Likes: 0
Received 0 Likes
on
0 Posts
Oh so I take it that the exhaust is not suppose to rub the rear bumper exhaust outlets....my back bumper is slightly burnt and I had the same issue with the exhaust hitting the sway bar but the exhaust was hit wrapped so it wouldnt tap the bar...the issue now is the rattling off the back bumper plastic and the exhaust.....regardless i'm happy with the sound it makes but yeah for the future i'm going with an exhaust thats mass produced.
#102
Destructo Girl
iTrader: (2)
Join Date: Sep 2007
Location: Harpers Ferry WV
Posts: 2,142
Likes: 0
Received 0 Likes
on
0 Posts
I've only seen 2 cars up close (like stopped to REALLY look at them) with this exhaust... Pun1sh3rZ, and a TT Nismo that's at their shop right now. Both of those systems seem to fit PERFECT, and they do sound AMAZING. When we were all waiting for Pun1sh3rZ to show up for a caravan to a local meet we could hear him coming from a mile away. It's got a distinctive sound, and IMO the tips look fantastic. My husband and I are both going to order it to replace the custom systems we had installed a few months ago.
#104
Registered User
iTrader: (12)
Join Date: Oct 2005
Location: Burtonsville, MD
Posts: 1,549
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Ex2cinaZ
I've only seen 2 cars up close (like stopped to REALLY look at them) with this exhaust... Pun1sh3rZ, and a TT Nismo that's at their shop right now. Both of those systems seem to fit PERFECT, and they do sound AMAZING. When we were all waiting for Pun1sh3rZ to show up for a caravan to a local meet we could hear him coming from a mile away. It's got a distinctive sound, and IMO the tips look fantastic. My husband and I are both going to order it to replace the custom systems we had installed a few months ago.
#107
Registered User
iTrader: (1)
The resonator on my aam single comes close to the driveshaft, but not hitting. The only part that rubs is where it goes over the rear crossmember, it pretty much rests on the crossmember. So I just used some heat wrap in that area to cushion it. I'm sure getting a different y-pipe might change the fitment some so it's not hitting.
Thread
Thread Starter
Forum
Replies
Last Post