Reliable shop in MD for FI install
#24
Registered User
iTrader: (12)
Join Date: Oct 2005
Location: Burtonsville, MD
Posts: 1,549
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by InjectedPerf
You might try PF Supercars. I know Ray (the owner) has a turbo'ed 350z and has had very good success with it. They are an hour from where you are.
http://www.pfsupercars.com/contact.htm
http://www.pfsupercars.com/contact.htm
#25
Registered User
Thread Starter
Join Date: Jan 2007
Location: Brussels belgium / GA
Posts: 1,598
Likes: 0
Received 0 Likes
on
0 Posts
Thanks again guys for steering me in the right direction. Just didnt want to do the FI route and have someone screw it up. Definately checking out function and will be calling dave soon.
#27
Cranky FI Owner
iTrader: (14)
Originally Posted by r0csfinest
damn ive been on this board the whole time and never ever heard of them! gotta check out the shop one day
#31
Cranky FI Owner
iTrader: (14)
Originally Posted by iStan
So, what did you end up going with? Or is it hush hush until it's finished?
#32
Registered User
iTrader: (2)
Join Date: Apr 2008
Location: Southeast
Posts: 663
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Alberto
You have likely seen the owners 861 whp Greddy TT car + 125 or so shot post on here-forcefedz. All done on stock head studs, stock head gasket, stock cooling, and no issues past 10,000 miles.
forcefedZ parts list from previous post:
-85lbs injectors
-intank walbro and a bosch 044 pump
-stock block with standard bore pistons (direct drop in)
-Pauter Rods with Nissan engine bearings
-Stock cylinder heads with BC stg2 cams (stock springs and retainers)
-Stock 18G's
-ARP head and main studs using OE head gaskets
-Water Injection (10% meth)
-VP Race Gas
-Zex Single nozzle kit
-Haltech Platinum EMS
#35
Originally Posted by r0csfinest
Is there a vid of it doing the 1/4 or something?
#37
Cranky FI Owner
iTrader: (14)
Originally Posted by Sean
I saw a car on a dyno.... that was about it. No numbers, nothing amazing worth making a video of...but at least the tester had ear defenders on....unlike some people who should do that.
Is there a vid of it doing the 1/4 or something?
Is there a vid of it doing the 1/4 or something?
At 600whp he ran 11.2 @ 131mph spinning. Video is on the forums. I saw it in person, was the night I ran 11.1....
If you want to see the 4" exhaust he could show you guys.
Thread
Thread Starter
Forum
Replies
Last Post