FS: ATI Procharger kit--380 injectors, Cobb
I am selling a full ATI Procharger kit for a G35. I just got it back from ATI last week and can include the paperwork for the rebuild. It has a new shaft and bearings. The impellor was replaced 3k miles ago as well as a full inspection done. It was a tuner kit I purchased, but then decided to buy all new piping from ATI as well. I have some extra couplers, new clamps, and rubber hoses I purchased but didnt need that I will toss in as well. The car has not even been run on the new piping and blower rebuild. I am selling it as a complete bolt on kit. I have the 6 psi pulleys and the 10 psi pulleys. I am selling this kit for 3200 plus shipping.
I also have a open cobb accessport I am selling for 250.
I have a set of 380cc Deatschworks injectors for 250. Please let me know if you have ay further questions about the parts.









I also have a open cobb accessport I am selling for 250.
I have a set of 380cc Deatschworks injectors for 250. Please let me know if you have ay further questions about the parts.









It will depend on your fuel system and which pulley you use. If you go 6psi, people normally see 350-375 rwhp. On 10psi my tuner was expecting to see 420 on a safe tune. These are the numbers people normally see. I have not installed it since the rebuild or tuned it, as I am now scrapping everything and going with some turbo v8 power haha. Im shooting for around 700rwhp
Trending Topics
They are drop in and plug right into the factory harness. Feel free to PM me for my PayPal address. I could pull them out tonight. They will need 2 o-rings that can be picked up at oreileys or Napa.
im sorry. started a new job and have been busy. i still have it and it will go to the first pm, then ill go on to the next. I am sorry for the delay. I still have the procharger kit as well


