Profec AUTO mode--PlEaSe HeLp!?!
#1
Sponsor
builtZmotors
builtZmotors
Thread Starter
iTrader: (21)
Join Date: Jul 2004
Location: Albuquerque, NM
Posts: 2,780
Likes: 0
Received 0 Likes
on
0 Posts
Profec AUTO mode--PlEaSe HeLp!?!
so... i can't seem to switch my profec-e01 to auto mode at 6lbs of boost... i follow the setup instructions... as far as the settings, then WOT in 3rd gear 3-4 times... but the entire time the auto icon blinks, it doesnt register the setting, and it only runs 4.5 lbs.. so in the meantime i'm back on the manual mode and running 6lbs no problem...but would like to keep it on auto
ANY SUGGESTIONS???
ANY SUGGESTIONS???
#4
Registered User
Join Date: Feb 2003
Location: Silverdale, WA
Posts: 449
Likes: 0
Received 0 Likes
on
0 Posts
Try setting Gain to 15. If that doesn't do add 2 to the gain till you get there. Just take it slow and watch the boost. Start should be 2.8 psi less than what target is.
Gary
Gary
#6
Sponsor
Forged Performance
Forged Performance
iTrader: (92)
350zDcalb....30% in the manual mode is much too much. That will easiliy take you to 7psi or more...depending on the gear.
Try increasing the gain...and keep doing the WOT runs until the program light stops flashing. It may look like you never hit your target, but once its learned, it gets really darn close.
Try increasing the gain...and keep doing the WOT runs until the program light stops flashing. It may look like you never hit your target, but once its learned, it gets really darn close.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
bcoffee20
Zs & Gs For Sale
5
11-19-2015 06:39 PM
Extreme Dimensions
Southern California
0
09-24-2015 03:35 PM