Kinetix Install Ques.-Gasket-
#1
Registered User
Thread Starter
iTrader: (2)
Join Date: Sep 2008
Location: Athens, Al
Posts: 92
Likes: 0
Received 0 Likes
on
0 Posts
Kinetix Install Ques.-Gasket-
On the Kinetix V+, it says to re-use the factory gasket ALONG with the gasket that comes on the manifold....AND to use a silicone to seal it.....is the factory gasket really Necessary? And if so, why?
Thanks,
Keith
Thanks,
Keith
#3
Registered User
iTrader: (15)
Join Date: Nov 2003
Location: Clarksville, Tennessee
Posts: 6,612
Likes: 0
Received 1 Like
on
1 Post
you would think that the people that made the plenum put that in the instructions for a reason. so i'm going to take a wild guess and say yes, it is needed. that is why it is called "install instructions"
#5
Registered User
iTrader: (19)
Join Date: May 2007
Location: Jacksonville, NC
Posts: 701
Likes: 0
Received 0 Likes
on
0 Posts
only reason i used the silicone was i bought the kinetix from a member on here and the gasket that i had was destroyed, so i called kinetix and they told me that that is what they use along side the gasket, and in my case i would have been fine.
#6
Registered User
Thread Starter
iTrader: (2)
Join Date: Sep 2008
Location: Athens, Al
Posts: 92
Likes: 0
Received 0 Likes
on
0 Posts
That and i have no clue where my factory gasket went after i put on my plenum spacer....
Last edited by KeithGT; 07-19-2009 at 06:31 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Gruppe-S
Body Interior
13
05-16-2016 10:42 PM