yet again another CEL and Slip on
#1
New Member
Thread Starter
Join Date: Sep 2008
Location: Knoxville, TN
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
yet again another CEL and Slip on
Today i was driving the 350 down the interstate. I went around 50 miles or so, car was running at normal temps and nothing seemed wrong at all. came to a 5 mph roll for about two miles. when the interstate cleared i started to accelerate, got to around 75-80 mph and the car sputtered once and seemed everything was fine, no lights came on. After another 50 miles i got to the destination and turned off the car. Was in the restaurant for about an hour. Went outside to start the car and could not get it started for about five minutes. the starter just kept spinning. Finally got it started, went and had codes pulled, got a knock sensor code and a cam sensor(passenger side) code.
First i guess i want to know if anyone has ever experienced this or had to replace a cam sensor. Also is the cam sensor located on the backside of the motor witrh a green clip connecting to it? any help would be appreciated
First i guess i want to know if anyone has ever experienced this or had to replace a cam sensor. Also is the cam sensor located on the backside of the motor witrh a green clip connecting to it? any help would be appreciated
#2
Registered User
see if this link helps any i just had to get mine replaces
http://www.350zmotoring.com/forums/3...2003-350z.html
http://www.350zmotoring.com/forums/3...2003-350z.html
Thread
Thread Starter
Forum
Replies
Last Post
Boots patrol
Exterior
6
11-07-2015 12:26 PM