issue with windows
#1
Registered User
Thread Starter
issue with windows
when i roll my windows up they click back down about 3 inches and they will not go up this little bit when you shut the door??
any thoughts. I believe it may be the door switches..
any advice would be great plan on going to the dealership to get it checked out
any thoughts. I believe it may be the door switches..
any advice would be great plan on going to the dealership to get it checked out
#4
Registered User
Thread Starter
#5
New Member
iTrader: (12)
No mine is different then that.... the motor i believe are fine. when i click the switches to go auto up. they go all the way up lock then roll down about 3 inches and stay. it does it on both of them. and if i go up to high when i close the clos the windows kick down again. its like everything the window lock up they way they are suppose to the windows roll back down about 3 inches. that is why i think it is the switch
This is what you need the whole piece.
Last edited by PikesPeakZ; 09-11-2011 at 04:34 PM.
#7
New Member
iTrader: (12)
I wouldn't replace both if you don't have to. Buy genuine Nissan though because you'll be replacing it again with an auto zone motor. I paid right around $180 I think for one. Here is a link so you know what to look for: http://www.conceptzperformance.com/C...117.107.186.42
I did my own install following the walk through so if you go that route feel free to pm me if you need help or have questions.
I did my own install following the walk through so if you go that route feel free to pm me if you need help or have questions.
Last edited by PikesPeakZ; 09-11-2011 at 05:00 PM.
Trending Topics
#9
Registered User
Thread Starter
Yesterday I took the doors apart and cleaned the motors. Now the door dont roll down after I get out of the car. But when Im an driving and i hit the auto up by clicking the switch all the way up they do the rolled up all the way and then kick down 2 inches. Could it be the swithes in the door panel?
#10
Registered User
Have you tried to do the window motor reset? Im not sure now with the window not rolling down but your original issue sounded like it could have been fixed simply by doing the reset.
Edit:
Dont know why it wont let me paste the URL but here it is:
H-TEE-TEE-PEE:\\http://www.350z*dash*tech.com/wiki/i...eset_Procedure
Edit:
Dont know why it wont let me paste the URL but here it is:
H-TEE-TEE-PEE:\\http://www.350z*dash*tech.com/wiki/i...eset_Procedure
Last edited by green_bread; 09-19-2011 at 06:44 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Colombo
Forced Induction
35
11-09-2020 10:27 AM