Hey guys

I was trying to replace one of the AC lines today and couldn't get the bugger to come off. Found out I needed a special disconnect tool, so I called up Autozone and asked, they said they have some so I went and bought it. It looked like it should work but when I got home and repeatedly yanked on the line, no go.

So two part question. Is this the right tool and I'm just a powderpuff, or did Autozone **** up again?



And if it's not the right tool, where can I find one. (tried NAPA and they didn't carry any)

Here's the connection I'm trying to get loose. Scratch marks from the yanking

 

solved

30 seconds after I posted this, got an answer. And there's even a youtube video for it. I hate it when I regress to a noob