Notices
Maintenance & Repair 350Z up keep and diagnosing/fixing problems

Nismo Shakes with very low RPM when idled (stopped)

Thread Tools
 
Search this Thread
 
Old Jun 23, 2014 | 06:32 AM
  #1  
xstylinpnoy757x's Avatar
xstylinpnoy757x
Thread Starter
Registered User
 
Joined: Oct 2009
Posts: 22
Likes: 0
From: Virginia
Default Nismo Shakes with very low RPM when idled (stopped)

Has anyone have problems where your Z starts to shake when you are idled? My Z sometimes have low RPMs (under 500RPMs) when idled or stopped. This also happens sometimes when I start the car and it sounds like its going to stall out. It stalls out on occasion.

I cleaned my Mass air flow sensor, and it fixed the issue, months later, it kept stalling out when I slow down, and pressing the gas won't help.. so I had to replace both of the MAF sensors (quite expensive).
But it still has low RPMs while idled and sometimes stalls out..

I'm afraid that if might stall out on the highway when there is traffic (living in DC sucks sometimes). I am thinking of replacing the spark plugs, and cleaning my K&N drop in air filter. My car is at 76k miles right now, and I haven't got a tuned yet.

Any ideas or tips..?!
Reply
Old Jun 23, 2014 | 06:56 AM
  #2  
Glover41's Avatar
Glover41
Registered User
 
Joined: May 2014
Posts: 53
Likes: 1
From: Oman.
Default

Would clean my TBs before i do or replace anything..
G.L ..
Reply
Old Jun 23, 2014 | 07:31 AM
  #3  
SQuaLZ's Avatar
SQuaLZ
New Member
 
Joined: Jul 2009
Posts: 3,382
Likes: 116
From: New York
Default

What are your mods?
Reply
Old Jun 23, 2014 | 07:47 AM
  #4  
xstylinpnoy757x's Avatar
xstylinpnoy757x
Thread Starter
Registered User
 
Joined: Oct 2009
Posts: 22
Likes: 0
From: Virginia
Default

It's the 350z 2008 Nismo.. No mods, but a K&N drop in filter...
Reply
Old Jun 23, 2014 | 10:09 AM
  #5  
guitman32's Avatar
guitman32
New Member
iTrader: (15)
 
Joined: Jul 2005
Posts: 1,998
Likes: 108
From: South FL
Default

Usually a vacuum leak somewhere in the intake track, maybe your MAF(s) are just done, or off chance could be a bad coil but that would only cause rough running usually not the sputter and die part.

Also if you have an exhaust leak before the secondary O2 sensors it might cause something similar but the leak would have to be pretty bad, to the point where you would smell it.

I would look at those MAFs, they say cleaning them usually isnt a long term solution. Next would be a vacuum leak somewhere, but since you havent done your plenum or anything like that I would be surprised if a vacuum leak just popped up out of nowhere considering the car isnt that old.
Reply
Old Jun 23, 2014 | 10:13 AM
  #6  
guitman32's Avatar
guitman32
New Member
iTrader: (15)
 
Joined: Jul 2005
Posts: 1,998
Likes: 108
From: South FL
Default

Are you getting a CEL?
Reply
Old Jun 23, 2014 | 10:26 AM
  #7  
xstylinpnoy757x's Avatar
xstylinpnoy757x
Thread Starter
Registered User
 
Joined: Oct 2009
Posts: 22
Likes: 0
From: Virginia
Default

There is no CEL, no engine lights on... I actually replaced both of the MAFs last week (should I flash the car after replacing this.?). The car is not stalling out much anymore, but it does feel like it will stall out when idled (stopped) due to it having low RPMs.
Reply
Old Jun 23, 2014 | 11:41 AM
  #8  
SQuaLZ's Avatar
SQuaLZ
New Member
 
Joined: Jul 2009
Posts: 3,382
Likes: 116
From: New York
Default

Maybe an idle relearn procedure? Just a guess if it is not stalling out anymore but is idling differently since you replaced the MAFs.
Reply
Old Jun 23, 2014 | 02:48 PM
  #9  
myfirstzcar's Avatar
myfirstzcar
Registered User
 
Joined: Jan 2010
Posts: 611
Likes: 1
From: western New York
Default

How much oil have you dumped on that k&n filter?
Reply
Old Jun 23, 2014 | 06:53 PM
  #10  
xstylinpnoy757x's Avatar
xstylinpnoy757x
Thread Starter
Registered User
 
Joined: Oct 2009
Posts: 22
Likes: 0
From: Virginia
Default

I bought the K&N filter brand new, and it says it comes pre oiled already, so I haven't add any additional oil. And yes, I haven't reflash the car ever since I replaced the MAFs... Also, it did stall out once this past week when I started the car... the RPMs was so low that it stalled out....

It's funny, not sure if this matters, but it was stalling out when it was below freezing, and since it got so hot here in DC, it started stalling out again. Not sure if the weather matters, but it might make a difference..

But cleaning the MAF fixed issue for a few months, then after replacing it, I can start driving it again, but the car still feels as if it is going to stall out again.... (very low RPMs on idled..)
Reply
Old Jun 24, 2014 | 01:10 AM
  #11  
myfirstzcar's Avatar
myfirstzcar
Registered User
 
Joined: Jan 2010
Posts: 611
Likes: 1
From: western New York
Default

Clean the mafs again.
Reply
Old Jun 27, 2014 | 04:22 AM
  #12  
difranchise's Avatar
difranchise
Registered User
 
Joined: Jun 2014
Posts: 42
Likes: 8
From: Ohio
Default

What about motor mounts?
I used to drive an 03 SER that did the same thing. Upon inspection i saw that one motor mount was deteriorated.
Good luck
Reply
Old Jun 27, 2014 | 07:21 AM
  #13  
SQuaLZ's Avatar
SQuaLZ
New Member
 
Joined: Jul 2009
Posts: 3,382
Likes: 116
From: New York
Default

Originally Posted by difranchise
What about motor mounts?
I used to drive an 03 SER that did the same thing. Upon inspection i saw that one motor mount was deteriorated.
Good luck
Motor mounts would cause shaking but not a low idle or stalling.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
liqalu04
Engine & Drivetrain
31
Jan 2, 2022 12:58 PM
Colombo
Forced Induction
35
Nov 9, 2020 10:27 AM




All times are GMT -8. The time now is 12:43 PM.