What is the best way to R&R an oil pan?
05-02-2015, 08:48 AM
#1
Registered User
Thread Starter
Join Date: Oct 2014
Location: Sgv
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
What is the best way to R&R an oil pan?
Hello people, Recently i pressure tested my oil. That being said when i put back my sensor i accidentally torqued it a bit too much, and cause the sensor area to crack. Right now i just JB Welded it with Marine Weld just to get it home from where it was. I know the oil heat will melt the jb weld so my next option is to just replace the upper oil pan.
Which is a better more efficient way to remove and replace the oil pan? From down under or to just take out the whole motor.?
TIA!
Which is a better more efficient way to remove and replace the oil pan? From down under or to just take out the whole motor.?
TIA!
05-05-2015, 08:47 PM
#5
350Z-holic
iTrader: (13)
Pull the block...
Thread
Thread Starter
Forum
Replies
Last Post