after ecu reset replaced both sensors still getting codeI
Thread Starter
Registered User
Joined: Jun 2018
Posts: 3
Likes: 0
From: Enid, Oklahoma
after ecu reset replaced both sensors still getting codeI
I have a 04 z that I did a ecu reset on afterwards very hard to start and the code P0340. I have replaced both sensors and checks all the wires and looked for vacuum leaks I have done another reset and code still comes up not sure what else to try
Last edited by Pruvis; Jun 21, 2018 at 07:23 AM.
I also had this problem when I installed my stereo and left the battery unplugged for a couple of days. I also got the same code and replaced the sensors which seemed to only help slightly. It was not until I had my car in a shop that specialized VQ's that they were able to perform a proper idle relearn and now my car starts up every time on a single crank. I'm running Autozone Cam Position Sensors.
It maybe worth trying to do a proper idle relearn on your car, even though when I tried I couldn't get it to fix the problem.....
It maybe worth trying to do a proper idle relearn on your car, even though when I tried I couldn't get it to fix the problem.....
Thread
Thread Starter
Forum
Replies
Last Post
phelannz
Maintenance & Repair
6
Feb 26, 2016 08:27 AM
350Z Project X
Maintenance & Repair
11
Oct 17, 2015 05:16 PM