I recieved a package from Adam@Z1 about 2 weeks ago with a few new bits for my Z

Awesome service & advice from Z1 as usual


Cusco Zero-2 Coilovers, Cusco Front Sway Bar, Cusco Rear Sway Bar & A Cusco Strut Brace.


After a painful 2 week wait to get them fitted, I had them fitted today











These are amazing, the car handles so much better now & feels a lot more planted than it did before. I think I may have to raise the car up a bit though as its a bit low & I've already scraped the mid pipe on my exhaust about 10 times.

Unfortunatley the Cusco Strut Brace rubs on the Kinetix plenum so I am selling the plenum now to replace it with a spacer

 

Raising it? I was going to say lower it some more! Loooks good though I love the new suspension setup looks BEEFFFY as hell.

 

nice

 

Very Nice Combo!

 

Looking good!

 

Looks good

 

scraping? what drop do you have? damn you have me concerned now, i was planning on getting tanabe nf210 (1.2 drop all around) and i have hks dual exhaust so probably i will scrape canisters

 

Mine only scrapes over the massive speed bumps that we have in this area

Not sure the exact amount its been dropped but i'll find out later on

 

Sweet!
How does the set-up ride? give us a review man!

*ring* "Where are you?"
"In the wheel funnel b*tch!"

 

Will give a full review tomorrow once I've hit the mountain roads

 

Nicely done!

 

+1

 

The fronts not bad just lower the rear to match.

 

 

how much drop is that?

 

If you can go lower, you should.

 

looks pretty good wish I could get a setup like that

 

Nice, those 18's? What's the rim & tire spec?

 

Nice.

If my car wasn't a daily driver, Cusco coilovers would have definitely been my next mod.

 

Thanks

It can go lower but if I do go lower then I probably won't be able to get my car out of my street.

Wheels a 19x9.5 & 19x10.5 +22 offset