Single back?
#1
Thread Starter
Registered User
iTrader: (22)
Joined: Aug 2007
Posts: 879
Likes: 0
From: Frostburg MD
Single back?
I am looking for a 3 inch or bigger single back i have a new project im doing and need one asap perferibly used if anyone knows some one getting rid of one point me in there direction i would like to have it in the Mid-A region, brandon doesnt matter to me because it is goin to be moddified a little bit .
#4
Originally Posted by SC 350Z
I am looking for a 3 inch or bigger single back i have a new project im doing and need one asap perferibly used if anyone knows some one getting rid of one point me in there direction i would like to have it in the Mid-A region, brandon doesnt matter to me because it is goin to be moddified a little bit .
Trending Topics
#9
Originally Posted by Eric the Ricer
Kind of hard to make an offer on a damaged piece without seeing it first.
What did Dave quote you to fix it, around 400 bucks?
What did Dave quote you to fix it, around 400 bucks?
#10
Originally Posted by Akabir47
Dude your not helping me out. It was 400 because of the labor rates but if your a DIYer it would probably run you close to 75. Thats why i asked what he was lookin to spend. I can take a pic and email it to him if he is interested.
#12
me and ethan were thinking that u should measure the diamater of the bent tip... cut it off so there is about 1-2inches left on it... then buy a new Titanium tip from HKS that is a ?TEEeny bit bigger.slide it over the 2inches of the JIC tip .
there are 2 set screws that keep it held on to the 2inches of the JIC tip.. and the HKS Ti tip will be showing..
the tip is strait show anyways so no performance will be tainted.
there are 2 set screws that keep it held on to the 2inches of the JIC tip.. and the HKS Ti tip will be showing..
the tip is strait show anyways so no performance will be tainted.
#14
Originally Posted by .steeeeZ33.
me and ethan were thinking that u should measure the diamater of the bent tip... cut it off so there is about 1-2inches left on it... then buy a new Titanium tip from HKS that is a ?TEEeny bit bigger.slide it over the 2inches of the JIC tip .
there are 2 set screws that keep it held on to the 2inches of the JIC tip.. and the HKS Ti tip will be showing..
the tip is strait show anyways so no performance will be tainted.
there are 2 set screws that keep it held on to the 2inches of the JIC tip.. and the HKS Ti tip will be showing..
the tip is strait show anyways so no performance will be tainted.
#18
Thread Starter
Registered User
iTrader: (22)
Joined: Aug 2007
Posts: 879
Likes: 0
From: Frostburg MD
Originally Posted by Akabir47
Dude your not helping me out. It was 400 because of the labor rates but if your a DIYer it would probably run you close to 75. Thats why i asked what he was lookin to spend. I can take a pic and email it to him if he is interested.