New dyno numbers: 294 rwhp
I still need to get my cams tuned but I dont know if i will ever have the time to go to austin and get it tuned at uprev. My exhaust cams do wierd things past 5800 rpms so I am going to disable them in the ecu at 5800 rpms to redline. You guys know for an NA build you can use vq35hr pistons for like 11.5 compression and they are a decent price from nissan.
Originally Posted by TheJerk
Motordyne's 1/2 inch spacer, or Crawfords manifold would both net you more power in the higher rpm ranges.
As for the cam timing changes, was that only limited to 6600rpm on the mrev motor, compared to the Rev-up with VVT on intake and Exhaust sides, and a higher redline?
As for the cam timing changes, was that only limited to 6600rpm on the mrev motor, compared to the Rev-up with VVT on intake and Exhaust sides, and a higher redline?
Originally Posted by rednezz
Well I took my car back to UpRev to retune after I pulled the intake standoff out of the motor. The car put down 294 rwhp. Much better but that is about all this motor is going to put down with my intake manifold. You can see the power the climbs strong to 6200 rpm then suddenly nose dives. Looks like its just not getting enough air flow. Hopefully the Cosworth manifold will solve this problem.
Last edited by IntenseFab; Mar 22, 2008 at 12:23 AM.
Originally Posted by kirradude1025
Pulleys? That would help...prob 8-10 hp
Originally Posted by IntenseFab
Any reason why you are running an N/A car excessively rich under WOT? 11.8 is quite a bit of fuel for no f/i. Tip in looks great but you are losing alot of power around 2100 RPM. Your graph should steadily increase and look alot less peaky.
Last edited by rednezz; Mar 22, 2008 at 08:12 AM.
Originally Posted by rednezz
Actually I just ran out of dyno time. I spent most of the dyno time tuning the cam advance instead of A/F ratio. I also had a bad coil pack and bad crank position sensor at the time and I wasn't aware of the problem. It made it very difficult to tune the car. I need to go back and retune the car...the power level of the car is significantly different after fixing the coil pack and crank sensor. I am dying to know what kinda of numbers I am putting down now.
Originally Posted by IntenseFab
Awesome! Well from the sounds of things you'd hang Stillen/HKS S/C Equipped Z's
Originally Posted by rednezz
Don't know about that but the car is no slouch...been able to pull away on my friends EVO VIII that runs 110 mph in the 1/4 mile.
Get to the track
Todd
Originally Posted by IntenseFab
Awesome! Well from the sounds of things you'd hang Stillen/HKS S/C Equipped Z's
Actually I bet this would tear a stillen setup a new one... maybe even some ST setups running low boost. It should deffinitely run 12's
Last edited by DanielW; Mar 24, 2008 at 06:34 PM.
Originally Posted by DanielW
Actually I bet this would tear a stillen setup a new one... maybe even some ST setups running low boost. It should deffinitely run 12's
