The big bad nitrous post
07-17-2005, 12:08 AM
#262
Evil Boy 4 LIFE
iTrader: (1)
Join Date: Jun 2005
Location: Interwebs
Posts: 2,925
Likes: 0
Received 0 Likes
on
0 Posts
ok so the zex kit dosnt come with a bottle mouting bracket? also will the zex kit work with the nx maximizer? i cant believe there has been no talk about the maximizer it gets rid of your windoswitching crap and you can dial in when you want to spray.. also i hear you can couple it with a wideband 02.. this is my plan anyways.. untill someone tells me differently
07-17-2005, 09:33 AM
#263
Registered User
Join Date: Jun 2005
Location: Calgary, AB
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Nitrous Express website says that the maximizer has been discontinued...anyone know more about this?
Link: http://www.fjoracing.com/products/Maximizer/nxmax.htm
Link: http://www.fjoracing.com/products/Maximizer/nxmax.htm
07-17-2005, 10:54 AM
#264
Evil Boy 4 LIFE
iTrader: (1)
Join Date: Jun 2005
Location: Interwebs
Posts: 2,925
Likes: 0
Received 0 Likes
on
0 Posts
"*** Please note that while we are continuing support for the NX Maximizer, this product has been discontinued and is superceded by the new Maximizer-II which features enhanced capabilities and features. for details."
05-12-2006, 08:50 AM
#267
I have a question for the nitrous guys..... with a wet kit, it would be a good idea to have the nozzle spraying directly into the neck of the penelum? I only ask because I'm about to run a 100 wet shot into the bottom of the neck of the aftermarket larger penelum and want to be sure there's not going to be a pooling issue..... thanks
05-12-2006, 09:45 AM
#268
Registered User
iTrader: (23)
Join Date: Mar 2003
Location: Detroit / Las Vegas
Posts: 1,712
Likes: 0
Received 0 Likes
on
0 Posts
you dont have to mount it on the plenum. mount it as close to the plenum as possible, but mount it on the intake. this way if you ever sell the plenum, you wont have to worry about a hole being in it. its also easier to remove the intake then to remove the plenum. pooling is a problem only when you mount the fogger far down in the intake (6inches+) where the shot has time to heat up and condense, or when bottle pressure is too low and the fuel does not vaporise properly. pooling can also happen when you leave nitrous in the main feed line for a long period of time and air builds up in it. this way when you spray, the fuel again wont vaporize properly and will pool and cause a backfire. a purge kit will take care of the air build up.
good luck.
good luck.
06-15-2009, 12:05 PM
#272
Registered User
Join Date: Jun 2009
Location: Eagle, ID
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
I read your previous post on nitrous and there is posted that people with the Venom system had problems because it was a dry system and were pushing it too hard.
The Venom system is not "entirely" dry because although it only has a single input nozzle the electronic control module taps into the injector harness and it modulates the injector signal making them to flow more fuel. So it can be sais that it's a "semi-wet" system. It's true that the Venom is a little expensive but it takes out the problem of jetting as the system uses pre-measured nozzles to inject the nitrous.
IMO the best is the ZEX system b/c of its simplicity and clean install.
The Venom system is not "entirely" dry because although it only has a single input nozzle the electronic control module taps into the injector harness and it modulates the injector signal making them to flow more fuel. So it can be sais that it's a "semi-wet" system. It's true that the Venom is a little expensive but it takes out the problem of jetting as the system uses pre-measured nozzles to inject the nitrous.
IMO the best is the ZEX system b/c of its simplicity and clean install.
07-22-2010, 10:46 AM
#277
with a typical 100 shot....you'd probably be looking at being able to make about 3 full 1/4 mile passes before you start having major pressure drops by the end of the run.
If you are talking just little squirts of the juice around.....hard to say how long a 10# bottle will last.
If you are talking just little squirts of the juice around.....hard to say how long a 10# bottle will last.
07-24-2010, 01:34 PM
#278
Retired Admin
iTrader: (95)
How long a 10 lb bottle lasts depends on the ambient temperature, your nitrous jet size, the duration of your sprays, your nitrous line length, etc.
For the most part, QuadCam is correct in that you only get a few, full passes with a 10 lb bottle.
For the most part, QuadCam is correct in that you only get a few, full passes with a 10 lb bottle.
